==++ MOTU 828mk3 Firmware v1.06 Update ++==
==++ for 64-bit Windows Vista and Windows XP ++==

This updater will install firmware version 1.06 to your 828mk3.  The updater
requires that you first install the current MOTU FireWire audio driver.  You can
download the driver installer from www.motu.com/download.

When the current driver is installed and the interface is detected by your
computer, you are ready to install the firmware update.  Disconnect all FireWire
devices from the computer except for the 828mk3, and then follow these
instructions:

1.  Turn off the 828mk3.  Press and hold the PAGE knob, and then turn on the
interface.  The 828mk3 will boot to the firmware update mode.

2.  If you're using Windows XP, the Windows Found New Hardware Wizard may open
and prompt you to connect to Windows Update to search for driver software.
Choose "No, not this time."  When prompted to choose whether to install drivers
automatically or choose them from a list, select "Install automatically."  If a
warning message about Windows Logo testing appears, click "Continue anyway."
When the Found New Hardware Wizard has completed, you should see a message
stating that the new hardware is ready to use.  (If you're using Windows Vista,
this process happens automatically and you can continue to step 3.)

3.  Launch the MOTU FX Updater 64 program.  Click the Update Now button to begin
installing the update.  Do not turn off the 828mk3 or disconnect it from the
computer during the firmware update process.

4.  When the update has completed, turn off the interface, turn it on again, and
then launch the MOTU Audio Console program.  At the bottom of the 828mk3 tab,
you should see that the interface's firmware version is now 1.06.

We hope you enjoy using your MOTU audio interface.  We welcome your comments and
suggestions.

Sincerely,
MOTU Hardware Development Team
www.motu.com/techsupport
www.motu.com/suggestions